HVACR practice exams can be used for self-assessment, professional-growth, and certification exam preparation. Our HVACR practice exam consists of questions developed by HVAC Excellence, the largest provider of certifications (more than 200,000) in the HVACR industry.

Our 300 question HVAC practice test provides:

assessment of broad based HVACR knowledge
practice in the various core specialty areas
benefit for self-assessment and professional-growth, as well as for exam preparation
use for students in trade-schools studying for course exams and for professional technicians sitting for certification exams
a good opportunity for practicing test taking skills and learning the subject matter

A 100 question EPA 608 practice test comes with our materials.

To get an idea of the types of questions on the full version HVACR Practice Test, try our free sample below:

View Answers as You Go

View 1 Question at a Time

1.	What is the symbol for impedance?
		a. R
		b. I
		c. Z
		d. P

2.	The safety ground conductor for A/C circuit is usually color coded _________.
		a. red
		b. green
		c. black
		d. white

3.	Heat which causes a change in temperature of a substance is called:
		a. latent heat.
		b. sensible heat.
		c. superheat.
		d. regular heat.

4.	What is heat, which causes a change in the state of a material without a change in temperature, called?
		a. Latent heat
		b. Sensible heat
		c. Superheat
		d. Regular heat

5.	What is a sling psychrometer used to measure?
		a. Latent heat
		b. Super heat
		c. Wet and dry bulb temperature
		d. Barometric pressure

6.	A compressor is operating with a discharge pressure of 235.3 psig and a suction pressure of 35.3 psig. What is the compression ratio (pumping ratio)?
		a. 10:1
		b. 8:1
		c. 7:1
		d. 5:1

7.	In a (direct expansion) evaporator, liquid refrigerant must boil away as close to the end of the coil as possible in order to:
		a. ensure proper oil return.
		b. ensure that frost does not accumulate.
		c. sub-cool the compressor.
		d. operate at high efficiency.

8.	An thermal expansion valve that is stuck wide open will cause ___________.
		a. low suction pressure
		b. a flooded evaporator
		c. excessive superheat
		d. a starved evaporator

9.	What is the major difference between a heat pump and an air conditioner?
		a. Condenser
		b. Thermostatic expansion valve
		c. Evaporator
		d. Reversing valve

10.	What device controls the supplementary electric heat according to the outdoor temperature?
		a. Auxiliary temperature control
		b. Outdoor auxiliary thermostat
		c. Outdoor ambient thermostat
		d. Indoor thermostat only

11.	Which of the following is not a factor that should be considered when installing an outdoor unit?
		a. Return air
		b. Wind factors
		c. Sound transmission
		d. Snow fall

12.	What is the minimum clearance for access panels on an outdoor condensing unit?
		a. 36 inches
		b. 30 inches
		c. 15 inches
		d. 10 inches

13.	One BTU is the amount of heat required to raise the temperature of:
		a. one pound of ice one-degree Fahrenheit.
		b. one pound of water one-degree Fahrenheit.
		c. one gallon of water one-degree Fahrenheit.
		d. one gallon of water eight degrees Fahrenheit.

14.	What is the primary composition of natural gas?
		a. 65 percent methane
		b. 75 percent methane
		c. 85 percent methane
		d. 95 percent methane

15.	The electric heat element is usually made of what material?
		a. Copper with a brass coating
		b. Nickel with a cadmium coating
		c. Nickel and steel
		d. Nickel and chromium

16.	Which of the following is an example of a resistive load?
		a. Bimetal switch
		b. Crankcase heater
		c. Transformer
		d. Motor

17.	An oversized heating and cooling system can cause which of the following?
		a. Operating cost and relative humidity in the structure will decrease significantly.
		b. Moisture damage to a furnace heat exchanger and inadequate humidity removal during cooling cycles.
		c. The structure will develop low humidity levels in the cooling season and high humidity in the winter.
		d. Equipment will last longer and require less energy to operate due to the shorter run time.

18.	When the temperatures of a structure both inside and outside are equal, there is _____.
		a. no heat transfer
		b. latent heat transfer to the outside
		c. thermal heat transfer of sensible heat
		d. a lower rate of relative humidity

19.	Polyolester (POE) oils stored in plastic containers will _______.
		a. separate
		b. become more alkaline
		c. become acidic
		d. absorb moisture through the plastic

20.	R-407C has _______-.
		a. a foul odor
		b. to be charged in the vapor phase
		c. the ability to fractionate
		d. no temperature glide

21.	What is a carbon footprint?
		a. The carbon deposits from burning gasoline.
		b. The amount of carbon dioxide that is produced to support your lifestyle.
		c. The amount of carbon in the atmosphere produced by the world's lifestyle.
		d. The amount of carbon in the stratosphere.

22.	What is energy management?
		a. A rule that the total amount of energy stays constant in an isolated system over time.
		b. Recovering energy lost while using mechanical equipment.
		c. Reading the electric and fuel gas meters every month.
		d. The monitoring and controlling of energy consuming devices.

Principles of Electrical and Refrigeration Theory

1.	What is the symbol for impedance?
		a. R
		b. I
		c. Z
		d. P
The symbol or letter for impedance is Z and it is represented by writing its magnitude and phase. Incorrect answer. Please choose another answer.

Air Conditioning

3.	Heat which causes a change in temperature of a substance is called:
		a. latent heat.
		b. sensible heat.
		c. superheat.
		d. regular heat.
Any time there is a change of temperature indicated by the thermometer the heat level or intensity can easily be measured. In the writings of the early scientists who provided the foundations of thermodynamics, sensible heat had a clear meaning in calorimetric. Incorrect answer. Please choose another answer.

Commercial Air Conditioning

5.	What is a sling psychrometer used to measure?
		a. Latent heat
		b. Super heat
		c. Wet and dry bulb temperature
		d. Barometric pressure
A sling psychrometer is a device that consist of two thermometers fitted in a hinged bracket used for spinning the two thermometers. One of the bulbs is kept moist with distilled water on a sock or wick placed over the thermometer's tip. As the thermometers are rotated, evaporation of water from the wick lowers the temperature indicating a lower temperature than that of the dry-bulb thermometer. This is the Wet bulb temperature which will be lower than the dry bulb and can never be above dry bulb measurement. The lower the relative humidity, the lower the wet bulb temperature. The difference in the two bulbs readings can be applied to a psychrometric chart to calculate relative humidity and other properties of air. Incorrect answer. Please choose another answer.

Commercial Refrigeration

7.	In a (direct expansion) evaporator, liquid refrigerant must boil away as close to the end of the coil as possible in order to:
		a. ensure proper oil return.
		b. ensure that frost does not accumulate.
		c. sub-cool the compressor.
		d. operate at high efficiency.
Direct type evaporators are designed to operate most efficiently with approximately 10 degrees superheat. In order to have superheat, all liquid must be boiled away before reaching the end of the evaporator. Incorrect answer. Please choose another answer.

Heat Pump Service

9.	What is the major difference between a heat pump and an air conditioner?
		a. Condenser
		b. Thermostatic expansion valve
		c. Evaporator
		d. Reversing valve
The reversing valve is the component that will reverse the flow of refrigerant when changing from air conditioning to heating. Incorrect answer. Please choose another answer.

Heat Pump Installation

11.	Which of the following is not a factor that should be considered when installing an outdoor unit?
		a. Return air
		b. Wind factors
		c. Sound transmission
		d. Snow fall
When installing the outdoor unit the return air is not a factor in the installation; all of the other answers are factors involving installation. Incorrect answer. Please choose another answer.

Gas, Oil and Combustion

13.	One BTU is the amount of heat required to raise the temperature of:
		a. one pound of ice one-degree Fahrenheit.
		b. one pound of water one-degree Fahrenheit.
		c. one gallon of water one-degree Fahrenheit.
		d. one gallon of water eight degrees Fahrenheit.
One BTU is the quantity of heat required to raise the temperature of one pound of water one degree Fahrenheit. The pound of water absorbs 1 BTU of energy to change from 68°F to 69°F. Incorrect answer. Please choose another answer.

Electric Heat

15.	The electric heat element is usually made of what material?
		a. Copper with a brass coating
		b. Nickel with a cadmium coating
		c. Nickel and steel
		d. Nickel and chromium
Heat elements are made of Ni-chrome which is nickel and chromium. They are combined to create a resistance wire. Incorrect answer. Please choose another answer.

Residential Heat Load Calculation

17.	An oversized heating and cooling system can cause which of the following?
		a. Operating cost and relative humidity in the structure will decrease significantly.
		b. Moisture damage to a furnace heat exchanger and inadequate humidity removal during cooling cycles.
		c. The structure will develop low humidity levels in the cooling season and high humidity in the winter.
		d. Equipment will last longer and require less energy to operate due to the shorter run time.
Over sizing a system will cause short cycling which will cause moisture problems. In the summer, not enough moisture will be removed making the structure uncomfortable with very poor energy usage. In the winter, the system will not heat up enough causing moisture to condense in the heat exchanger, as well as the venting system, shorting the life of the system. Incorrect answer. Please choose another answer.

Universal R-410A Safety and Training

19.	Polyolester (POE) oils stored in plastic containers will _______.
		a. separate
		b. become more alkaline
		c. become acidic
		d. absorb moisture through the plastic
Polyolester (POE) Oils are very hygroscopic and must be stored in a metal containers. Plastics containers may be permeable to moisture. Incorrect answer. Please choose another answer.

Green Awareness

21.	What is a carbon footprint?
		a. The carbon deposits from burning gasoline.
		b. The amount of carbon dioxide that is produced to support your lifestyle.
		c. The amount of carbon in the atmosphere produced by the world's lifestyle.
		d. The amount of carbon in the stratosphere.
A carbon footprint is an estimate of how much carbon dioxide is produced to support a person's lifestyle. Essentially, it measures an individual's impact on the climate based on how much carbon dioxide the person produces. Factors that contribute to a carbon footprint include the individual's travel methods and general home energy usage. Incorrect answer. Please choose another answer.

HVAC Practice Exam